Here is where we are with our manual ventilator automation project. This is a render and not a photo.
Changes from this image include adding carrying handles, and the control panel will have a slightly different layout and we will mark the function of the switches and dials with bright white laser marking. We are presently completing the electric circuitry, and we are going to add a mode that enables the patient's natural breathing to control the pulses.
When the patient begins naturally drawing in air, a pressure sensor uses that to signal an assisted breath. By tomorrow, we should have more than half of the raw materials here for the 100 unit production. Trying to get this done quick, but also make it the way it should be made.